Print
Category: Studio Build Blog
Hits: 1634

Not a great deal happened in the last few weeks except for some tidying of the outer door frame.  The frame itself had been well and truly secured into position but there were a multitude of gaps and holes between it and the brickwork. The plan was to fill any small gaps with filler and mortar for larger areas mostly at the lower edges of the wooden lintel either side of the frame. I also had about a 3mm gap between the top edge of the door frame and the lintel which needed to be blocked in. For this I found some angle iron in the garage which was just about the perfect fit. I had to use two lengths for the full width of the frame. I added a bit of filler to be sure there were no leaky points. These were hammered into place and finished the job quite nicely.

For the final finish framing around the door I picked up some 1 x 4" planks which were cut and nailed into position on the two sides and the top only. These required some routing to allow for the inaccuracies of the brickwork. Once in position these were painted.

The door originally had a large piece screwed into the lintel as a bit of a rain splash guard. I still had this and it was actually still very sound so I refitted this into place. Once it was given a couple of coats it looked pretty good.

Photo to follow...